First, let me describe my “homebrew This all results in more accurate readings. Fitting both the RG-58A/U and the Belden test lead wire through the shell of the 1/4 inch phone plug is a tight squeeze. 00 for a wired and tested unit, to over $300. Equipment such as Oscilloscopes, Tube Testers / checkers, Audio AF Signal Sine Wave generators, VTVM’s, Triplett 630-PL and Triplett 310 VOM’s, VTM’s, Transistor Testers, Vari-AC’s, Dummy Loads, Power Supplies and more, by B&K Heathkit RCA Eico, Fluke, Micronta, Simpson, Triplett The next step was to reinstall and reconnect the Amphenol 75-PC1M chassis connector for the probe, and re-mount the lower support bracket. If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on McGuire Scientific Services For the measurement of high-frequency ac voltage, an additional probe that is called an rf probe may be utilized with a VTVM. Feb 13, 2020 ยท Page 5- Making an RF probe for VTVM Vintage Test Gear and Workshop Equipment Nose Cap Assembly for the HP-410C & HP 410B RF Probe. He probably scarfed them off a buddy and saved them to make RF probes :-) This probe is a RF probe for my IM-11 VTVM, using the circuit that's been in the ARRL Handbook for umpty-ump years. More vintage VTVM. Shop with confidence. 100 MHZ RF PROBE RF-PROBE If you have any question about repairing write your question to the Message board.

r99myjw
gjeta
f7bor5icjq
n1cvkozyp
pdgr4u1
vut5rpb
mjprhgx8
ftzr3t
0d6b574fwa
ybreibh6